783506
17
Zoom out
Zoom in
Previous page
1/29
Next page
3332
immediately and contact an official repair or service centre. Do not attempt
to repair any damage yourself.
Unplug the machine before removing any detachable parts and before
cleaning the machine. This is to prevent the risk of short circuit and
electrical shock.
Before connecting the appliance to a power source, make sure the appliance
is correctly assembled.
Do not use the machine without ingredients to prevent damage to the
moving parts of the unit.
The machine should be placed on a horizontal and stable surface. To
prevent damage to the machine, do not place it on a sloping surface, carpet,
textile, plastic, paper or flammable materials.
The unit is equipped with an overload and damage protection system. This
switches the machine off automatically after 15 minutes of continuous
use. Unplug the machine and wait at least 30 minutes after an automatic
switch-off before resuming pressing to allow the machine to cool down.
If the press chamber becomes overloaded or obstructed during pressing,
the machine will stop automatically and continue automatically after a few
seconds. If the machine stops again after this, use the reverse function to
clear the chamber. If this does not work, switch off, unplug the machine,
clean the machine and remove the ingredients before continuing with the
pressing.
If the machine beeps after starting or during operation and the control
buttons do not work, unplug it and disassemble, clean and restart it
according to the instructions. If the problem persists, contact an authorized
repair center or authorized dealer.
All parts of the machine that come into contact with food during pressing,
comply with all certification requirements for materials in contact with food.
Plastic parts which come in contact with food such as carrots and beets may
become discolored. This phenomenon is normal and not harmful to your health.
Clean the removable parts immediately after each use of the unit. Be careful
when cleaning the parts to avoid damage or injury.
Do not use abrasive, corrosive, strong, or aggressive detergents to clean the
unit or its parts. Do not heat, wash in dishwasher or clean at temperatures
or agents higher than 60°C.
Standby mode: When the device has not been used for more than 5 minutes,
it automatically switches to standby mode to save energy consumption.
This device is intended for domestic use and similar applications. Do not use
the device outdoors.
Store and operate the unit only in dry and heated areas and not in an
ambient temperature below 5°C or a relative humidity above 80%.
Repairs and maintenance on the appliance should only be carried out by
authorized Espressions service points. As Espressions regularly works to
improve its products, designs and specifications may change.
Pack and protect the unit carefully during transport and storage.
Important guidelines for safe slow juicing
For efficient and safe operation of the appliance, it is recommended to cut
the ingredients into smaller pieces before pressing. It is recommended to
cut harder and tough pieces of fruits and vegetables smaller than 5 x 5 cm
and to add and press them one by one.
Fruits and vegetables that contain no or virtually no juice such as banana
and avocado are not suitable for pressing.
Peel ginger and cut it into pieces of approximately 4 cm before pressing in
order to prevent damage to the appliance.
Fruits with pips and large hard seeds (plums, peaches, grapes, kakis,
apricots, mangoes, etc.) as well as fruits with firm skin (citrus fruits, mango,
etc.) may clog, overload and damage the juicer. Carefully remove pits, seeds
and peels before pressing to prevent damage to the appliance.
The machine is not suitable for pressing coconut, sugar cane and other
fibrous foods.
Peel citrus fruits before squeezing them.
IMPORTANT
Clean the fruit carefully and cut it into smaller pieces prior to pressing so that the pressing screw
can feed and press it properly. If pieces remain in the hopper, use only the provided pusher to
push them towards the squeezing screw. If ingredients are stuck so tightly that they cannot be
pushed through with the pusher, use the reverse function to rotate in the opposite direction. If
the ingredients continue to block the Smart Slow Juicer, unplug and remove the hard pieces.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Espressions EP6900 s Smart Slow Juicer at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Espressions EP6900 s Smart Slow Juicer in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4.99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info