480732
12
Zoom out
Zoom in
Previous page
1/68
Next page
The SIM gives you three chances to enter the PIN
correctly. If the PIN is entered incorrectly three
times, the message ‘‘SIM BLOCKD’’ (SIM is
blocked) is displayed.
Should this happen, refer to the chapter Problems You Can
Solve.
After the PIN has been entered correctly, the phone
searches for a GSM network and the
message‘‘SEARCHING’’ is displayed.
Once a GSM network has been found, three short beeps are
heard and the SERV (Service) indicator comes on in the
display. An abbreviation for the GSM network is displayed
on the left of the display. You may now make and receive
calls.
A signal strength meter shows the strength of the
received signal, 0 to 5. A value of 5 indicates a strong signal
A battery meter is shown on the right of the display. It
starts at 5, after a fully charged battery has been attached
to the phone. As the battery loses charge, the battery meter
shows this in steps of 1, until 0 is shown when the battery
has no charge left. You can read more about this in the
chapter Batteries and Recharging.
Note the following points:
The phone will search for the ‘‘home’’ network. If this is not
available, the phone will search for a GSM network from
those in range, provided that Automatic Network
Selection is chosen.
If Manual Network Selection is chosen, and the ‘‘home’’
network is not available, ‘‘SEL NETW’’ (Select Network) is
displayed. Then you have to select a GSM network
yourself. You can read more about this in the description
of Special Function Nos. 7 and 9 in the chapter Special
Functions.
The SERV indicator flashes:
This indicates that a GSM network is in range, but the
phone will not register on that network. You can, however,
make emergency calls. Refer to the section Emergency
Calls, later in this chapter,
The message ‘‘NO NETW’’ (No Net-
work) is displayed:
No network is available.The reason may be:
You are in an area which is not covered by a network
The received signal is too weak.Try moving the phone or
the car to obtain a stronger signal. Refer to the chapter
Problems You Can Solve.
Network
Battery meter
Signal strength meter
Basic Operation
7
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ericsson GH198 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ericsson GH198 in the language / languages: English as an attachment in your email.

The manual is 0,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info