621620
23
Zoom out
Zoom in
Previous page
1/36
Next page
22
6. MAINTENANCE
Warning: for your own safety, turn switch “OFF” and remove plug from power
source outlet before maintaining or lubricating your lathe.
1 Regular maintenance will increase durability and reliability.
2 Periodically lubricate the ram in the tailstock with oil. All ball bearings are
packet with grease at the factory; they require no further lubrication.
3 Frequently blow out any dust that may accumulate inside the motor.
4 A coat of automobile-type wax applied to the bed will help to keep the
surfaces clean and allow the tool rest and tailstock to move freely.
7 If the power cord is worn or cut, or damaged in any way, have it replaced
immediately.
7. TROUBLE SHOOTING
Trouble Probable cause Remedy
Motor will not run 1. Defective on/off switch
Defective switch cord
2. Burned out motor
1. Replace defective parts
before using lathe again
2. Any attempt to repair this
motor may cause a hazard
unless repair is done by a
qualified service technician
Lathe slows down
when turning
1. V-belt too loose 1. Adjust belt tension
Tailstock rocks back
and forth
excessively
1. Adjusting screw is too
loose
1. Adjust screw
Headstock loose on
bed
1. Setscrew not tight 1. Tighten setscrew
Wood burns at
tailstock end
1. Cup center too tight or
not lubricated
1. Back off tailstock ram and
lubricate cup center
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ergofix 79585 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ergofix 79585 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info