Manual Ergofix 79585 (page 22 of 36) (English, German, Dutch, French)

621620

Zoom out

Zoom in

1/36

Changing speeds

The belt is shown positioned on the second steps from the outside end of the

pulley in fig. 9. This causes the lathe to turn at 2520 rpm. Refer to fig. 10; suppose

you wish to run the lathe slower, after refering to the speed chart (say 1560 rpm)

you must shift the belt inward.

Caution: make sure the power cord is removed from the outlet before attempting to

change the belt position.

Raise the belt guard:

- to make the lathe go slower shift belt inward.

- to make the lathe go faster shift belt outward.

Rotate the motor pulley counterclockwise with the left hand while pushing on the

belt with you right hand. Continue to rotate the pulley while pushing on the belt

until it “climbs” down into the next step of the motor pulley.

Now rotate the spindle pulley clockwise with your right hand while pushing on the

belt with your left hand. The belt will climb up into the third next of the spindle

pulley.

Rotate the spindle pulley clockwise with your right hand. Pull on the belt while

rotating the pulley until it climbs down into the next smaller step. Now rotate motor

pulley counterclockwise with your left hand while pulling on the belt with your right

hand. The belt will climb up into the next larger step.

Belt tension adjustment

Belt tension is provided by the weight of the motor pivoting the motor mounting

bracket downward through the hinge of the hinge bracket. To decrease the belt

tension, tighten the adjustment bolt located in the corner of the motor mounting

bracket, thus restricting downward pivoting travel. Conversly, loosening the

adjusting bolt allows increased pivot on the bracket, thus increasing belt tension.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ergofix 79585 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,34 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ergofix 79585 Manual

Product: