621622
32
Zoom out
Zoom in
Previous page
1/52
Next page
30
8. TROUBLE SHOOTING
PROBLEM
PROBABLE CAUSE
REMEDY SUGGESTED
Motor stops starting. Overload protection
device disengaged to
protect the log spliter from
being damaged.
Contact a qualified
electrician for opening the
pushbutton box to engage
the overload protection
device inside *
The machine fails to split
logs.
Log is improperly
positioned.
Refer to chapter
5. OPERATION.
The sizes or hardness of
the log exceeds the
capacity of the machine.
Reduce the log sizes
before splitting it on the
log splitter.
Wedge cutting edge is
blunt.
Refer to chapter
7. MAINTENANCE.
Oil leaks. Locate leaks and contact
the dealer.
Unauthorized adjustment
was made on max.
pressure limiting screw.
Lower max. pressure
rating was set.
Contact the dealer.
The log pusher moves
jerkily, taking unfamiliar
noise or vibrating a lot.
Lack of hydraulic oil and
excessive air in the
hydraulic system.
Check oil level for possible
oil refilling. Contact the
dealer.
Oil leaks around cylinder
ram or from other points.
Air sealed in hydraulic
system while operating.
Loosen bleed screw by
some rotations before
operating the log splitter.
Bleed screw is not
tightened before moving
the log splitter.
Tighten the bleed screw
up before moving the log
splitter.
Oil drain bolt with dipstick
is not tight.
Tighten the oil drain bolt
with dipstick.
Hydraulic control valve
assembly and/or seal(s)
worn.
Contact the dealer.
* Engaging overload protection device in the pushbutton box (instructions for
qualified electricians only) (see drawing page 41).
- Make sure the log splitter is unplugged.
- Remove the pushbutton box cover to reach the overload protection device.
- Push the button of the overload protection device to engage it.
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ergofix 77205 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ergofix 77205 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info