Manual Ergofix 77205 (page 25 of 52) (English, German, Dutch, French)

621622

Zoom out

Zoom in

1/52

 The ends of the logs must be cut squarely to prevent damaging the

machine. The branches must be cut off flush with the trunk.

 Never try to split logs larger than those indicated in chapter 2.0. This could be

dangerous and may damage the machine.

 Break wood in the direction of the grain. Do not place wood across the log splitter

and leave it in that position for splitting; it may be dangerous and may seriously

damage the machine.

 Never attempt to cut two logs at once; one may fly up and hit you.

 If the log moves away from the blade, retract the ram or the blade and turn the log

through 90°.

 Do not attempt to load the log in the log splitter while the ram is in motion; you

could get trapped and injured.

 Keep your hands well away from any splits and cracks which open in the log;

these may close suddenly and crush or amputate your fingers.

 Never force the log splitter for more than 5 seconds keeping the cylinder under

pressure in the attempt to split excessively hard wood. After this time interval, the

oil under pressure is overheated and the machine could be damaged. It is thus

better to stop and rotate the log by 90° to see whether it can be split in a different

position. In any case, if you are not able to split the log, this means that its

hardness exceeds the capacity of the machine and thus that the log should be

discarded so as not ot damage the log splitter.

 Do not force the blade by pushing the log on the upper part; as this can cause

the blade to break or damage the body of the machine. Always set the log on the

guides.

 Never leave the machine unattended while it is running. If you leave the machine,

even for a short time, remove the power supply or any possible cause of

accidental start-up.

 The log splitter must never be used by an operator who is under the influence of

alcohol, drugs, medicines, or who is tired. A clear mind is essential for safety.

 Never request the assistance of another person to help you remove a jammed

log.

 Check that the electric circuit is adequately protected and that it corresponds with

the power, voltage and frequency of the motor. Check that there is a ground

connection and a regulation differential switch upstream.

 Use cables with a section of 2,5 mm². Avoid use of free and inadequately

insulated connections. Connections must be made with protected materials

suitable for outdoor use. Do not use cables over 10 metres long, as excessively

long cables or those with inadequate section can cause voltage drops that

prevent motor from developing its full power.

 Never open the pushbutton box on the motor. Should this be necessary, contact

a qualified electrician.

 Make sure that the machine and the cable never come in contact with water.

 Treat the power cable with care. Do not attempt to move the machine by pulling

the cable. Do not yank the cable to unplug it; keep the cable away from excessive

heat, oil and sharp objects.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ergofix 77205 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,1 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ergofix 77205 Manual

Product: