621632

Ergofix 76301 Manual

14
Zoom out
Zoom in
Previous page
1/25
Next page
12
in good condition.
Do not operate the grinder with the wheel guard off.
Do not use the grinding wheels for cutting purposes.
Do not overload the grinder.
Use a wheel dresser to remove burrs from the grinding wheel.
Maintain a distance between the spark breaker and the grinding wheel of less
than 1,6 mm (1/16”).
6. ASSEMBLY
Assemble the eye shields, spark breakers and tool rests using the screws, etc.
provided. Be sure to position both the tool rests and spark breakers no more than
1,6 mm (1/16”) from the edge of the grinding wheel.
It is advisable to secure the bench grinder to the workbench or stand.
7. OPERATION
1. After switching the grinder on, allow it to reach full speed before commencing
the grinding operation.
2. The eye shields can be adjusted and should be positioned to allow the operator
a clear view on the work through the shields.
3. The appropriate adjustments of the tool rests will provide the correct working
angle for efficient grinding. As the diameter of the grinding wheel is subject to
wear, it will be necessary to re-adjust the tool rests positions to maintain the
correct gap of less than 1,6 mm (1/16”) with the edge of the grinding wheel.
8. REMOVING OR CHANGING THE GRINDING WHEELS
To renew or change the grinding wheels, follow the steps mentioned below:
a) Disconnect the power supply cord.
b) Remove the outside covers, left and right.
c) Holding the grinding wheel firmly remove the nut and flange from the shaft with
a spanner. Note that the left wheel nut has a left hand thread and the right
wheel nut has a right hand thread.
d) Remove the old wheel and replace it with the new wheel.
e) Reassemble the flange, nut and outside covers.
f) Allow the grinder to run for one minute to ensure the grinding wheel is not out
of balance, before commencing any grinding work.
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ergofix 76301 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ergofix 76301 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info