779795
29
Zoom out
Zoom in
Previous page
1/37
Next page
EN
29
Take the cutting slit into consideration when cutting along marked cutting
lines. Do not cut directly on the line but next to it.
6. Pull the operating handle (1) forwards until the centre of the saw blade (34) is
directly over the front edge of the workpiece.
WARNING! Turn the lower retractable blade guard (32) by hand to test if
WARNING! Always ensure the saw blade does not interfere with the
fence or any other parts. Remove the fence if necessary.
7.
reach maximum speed.
8. Lower the saw blade to the workpiece slowly.
9. Push the operating handle rearwards to its full extent to cut through the width of
the workpiece.
10. Only apply proper feeding force. Higher feeding force will not increase but lower
the performance of the product, overheat the blade tips and leads to low cutting
surface/edge quality.
11. Switch the product off and allow the saw blade to come to a complete stop before
lifting it from the workpiece.
02 Mitre cutting
Mitre cutting is the same as slide cutting, except that the mitre angle is set to an angle
other than 0°.
1. Adjust the turntable to the desired mitre angle. Make sure the turntable locking
2. Follow the same instruction of “Operation – Slide cutting”.
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Erbauer EMIS216S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Erbauer EMIS216S in the language / languages: English as an attachment in your email.

The manual is 5.45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info