779795
27
Zoom out
Zoom in
Previous page
1/37
Next page
EN
27
06 Adjusting fence (Fig. P)
1. Unlock the fence locking lever (37) (step 1).
2. Slide the fence (13) to desired position (step 2).
3. Lock the fence locking lever (37) (step 3).
Ensure the saw blade does not interfere with the fence by conducting a
“dry run” with the cutting head set to the required bevel and mitre angle.
07 Adjusting workpiece clamp (Fig. Q)
The workpiece clamp (11) can be assembled on either side of the base. Use it to
support workpieces of different thickness by adjusting the height of the bracket (11d)
and plate (11c).
Ensure the motor housing does not interfere with the clamp while
operation with the cutting head set to the required bevel and mitre angle.
1. Loosen the locking knob (11a) (step 1) on the height adjustment pillar (11b) and
adjust the bracket (11d) to the desired height (step 2). Tighten the locking knob to
secure the bracket (step 3).
2. Press the locking button (11e) and hold it in position (step 4). Adjust the height of
the plate (11c) to the surface of the workpiece (step 5).
3. Rotate the height adjustment knob (11f) clockwise tightly to secure the workpiece
before operation (step 6).
Add a small scrap piece of thin plywood under the workpiece clamp to
avoid marking the workpiece.
08 LED light (Fig. R, S)
1. Switch the LED light (25) on by pressing the “light” symbol of the LED light switch
(2).
2. Switch the LED light off by pressing the “OFF” of the LED light switch.
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Erbauer EMIS216S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Erbauer EMIS216S in the language / languages: English as an attachment in your email.

The manual is 5.45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info