779795
23
Zoom out
Zoom in
Previous page
1/37
Next page
EN
23
7.
screw (34a). Tighten the clamping screw anti-clockwise with the provided multi tool
while the spindle locking button (26) is pressed.
8.
9. Push the lower retractable blade guard to slide the guard mounting plate (33)
downward and tighten the locking screw (33a) with the provided multi tool.
10. Close the lower retractable blade guard (32) afterwards.
06 Bench mounting
There are 4 mounting holes (12) at each corner of the base (39) to facilitate bench
mounting.
1. Place the mitre saw over the workbench tabletop and mark four locations on top of
the workbench that correspond to the mounting hole positions.
2. Drill four mounting holes (Ø11 mm) at the marked location of the workbench.
3. Place the mitre saw on the workbench and align the mounting holes of the base
with the drilled holes in the workbench.
4. Firmly secure the mitre saw to the bench surface with 4 bolts (not provided).
WARNING! For stability, turn the support bolt (19) clockwise to make
sure it contacts with the bench surface.
5. Carefully check the workbench after mounting to make sure that no movement can
occur during use. If any tipping, sliding, or other movement is noted, secure the
07 Dust extraction (Fig. G, H, I)
WARNING! Always attach a dust extraction device when using this
product to keep the working area clean!
Wear a dust mask when operating this product! Dust can be harmful to
health!
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Erbauer EMIS216S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Erbauer EMIS216S in the language / languages: English as an attachment in your email.

The manual is 5.45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info