Related Information
& “Cleaning the Paper Path” on page 125
& “Cleaning the Scanner Glass” on page 128
& “Cleaning the ADF” on page 126
& “Print Quality Is Poor” on page 155
An Image of the Reverse Side of the Original Appears in the Copied
Image
❏ For a thin original, place the original on the scanner glass and then place a piece of black paper over it.
❏ Lower the copy density setting on the control panel.
The Position, Size, or Margins of the Printout Are Incorrect
❏ Load paper in the correct direction, and slide the edge guides against the edges of the paper.
❏ When placing the originals on the scanner glass, align the corner of the original with the corner indicated by a
symbol on the frame of the scanner glass. If the edges of the copy are cropped o, move the original slightly
away from the corner.
❏ When you place multiple originals on the scanner glass to copy them separately, but they are copied onto a
single sheet, place the originals at least 20 mm (0.8 inch) apart. If the problem continues, place one original at a
time.
❏ Clean the scanner glass and the document cover. If there is dust or stains on the glass, the copy area may extend
to include the dust or stains, resulting in the wrong printing position or small images.
❏ Select the appropriate size setting for the original on the control panel.
❏ Select the appropriate paper size setting on the control panel or in the printer driver.
❏ Adjust the margin setting in the application so that it falls within the printable area.
Related Information
& “Loading Paper in the Paper Cassette” on page 42
& “Loading Paper in the Rear Paper Feed” on page 44
& “Loading Paper in the Front Paper Feed Slot” on page 46
& “Placing Originals” on page 49
& “Cleaning the Scanner Glass” on page 128
& “Printable Area” on page 170
Paper Is Smeared or Scued
Check the following if the paper is smeared or scued when printing.
❏ Clean the paper path.
❏ Clean the scanner glass and the document cover.
❏ Load paper in the correct direction.
❏ When performing manual 2-sided printing, make sure that the ink is completely dry before reloading the paper.
User's Guide
Solving Problems
157
