H Manualswitch
Use this switch to select the manual take-up direction. The selected option takes effect when the Auto switch is in
the Off position.
I Casters
There are two casters on each leg. Once installation is complete, the front casters should be kept locked while the
printer is in use.
If the stand fixing screw is lowered too much, the caster rises off the floor. Do not use the printer when a caster is off
the floor.
J Waste Ink Bottle holder
Place the Waste Ink Bottle in this holder.
K Stand fixing screw
In addition to locking the casters, the stand fixing screws also keep the printer securely in place. The stand fixing
screws cannot be used for horizontal adjustment of the printer. After installing the printer, keep it securely in place
during use.
L Waste Ink Bottle
Waste ink collects in this bottle.
Replace with a new Waste Ink Bottle when the level approaches the line.
M Stopper
The stopper prevents splatter when the waste ink is ejected.
Fit the stopper closely to the mouth of the Waste Ink Bottle in most situations.
N Waste ink tube
Waste ink is discharged from this tube. Be sure the end of this tube is in the Waste Ink Bottle while the printer is in
use.
O Ink tank
Holds ink used for printing.
P Slider
U “Slider” on page 13
Q Lock lever
Raise the lock lever to unlock the slider for removal when replacing the chip unit. Always lower the lock lever into
the locked position after inserting the slider.
R Chip unit check lamp
This lamp turns on when a message related to the chip unit is displayed.
On : Check the contents of the error on the control panel’s screen and deal with the error.
Off : No error.
S AC inlet
Connects the power cable.
T LAN port
U “LAN port” on page 13
SC-F7100 Series/SC-F7000 Series User's Guide
Introduction
11
