20060
17
Zoom out
Zoom in
Previous page
1/28
Next page
17
English
Setting up the Printer
Connecting the Power Cord
Note:
Most illustrations shown in this section are for EPSON
Stylus Pro 9800/9400, so they may vary in appearance
from EPSON Stylus Pro 7800/7400. The instructions
are the same, except as noted.
1. Check the label on the back of the printer to
make sure the voltage required by the printer
matches that of the wall outlet. Also, make
sure that you have the correct power cord for
your power source.
c
Caution:
It is not possible to change the printer’s
voltage. If the rated voltage and your outlet
voltage do not match, do not plug in the
power cord, and contact your dealer for
assistance.
2. Connect the power cord to the AC inlet on the
back of the printer.
3. Route the power cord through the clamps at
the rear of the printer. The cord can be routed
to either the left or right side.
4. Plug the power cord into a properly grounded
electrical outlet.
c
Caution:
Do not use an outlet that is controlled by an
automatic timer or wall switch. Otherwise,
accidental shut down or damage to your
printer may occur.
Installing the Ink Cartridges
To install the ink cartridges, follow the
instructions below.
w
Warnings:
The ink cartridges are self-contained units.
Under ordinary use, ink will not leak from the
cartridges. If ink does get on your hands, wash
them thoroughly with soap and water. If ink gets
into your eyes, flush them immediately with
water.
Note:
The ink cartridges included with your printer are
primarily for initial setup. Because your printer
will use large quantities of ink during the setup
process, you may need to replace the ink cartridges
soon.
Initial ink charging requires approximately
10 minutes.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Epson STYLUSPro9800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Epson STYLUSPro9800 in the language / languages: English as an attachment in your email.

The manual is 0,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Epson STYLUSPro9800

Epson STYLUSPro9800 User Manual - English - 385 pages

Epson STYLUSPro9800 Installation Guide - German - 28 pages

Epson STYLUSPro9800 User Manual - German - 422 pages

Epson STYLUSPro9800 Installation Guide - Dutch - 28 pages

Epson STYLUSPro9800 User Manual - Dutch - 416 pages

Epson STYLUSPro9800 User Manual - Spanish - 423 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info