D Casters
ere are two casters on each leg. e casters are normally kept locked once the printer is in place.
E Stacker (for plain paper)
Attach this stacker to the front of the printer in this way when continuously printing multiple sheets of plain
paper from the auto sheet feeder. e printed paper is stacked in this tray aer ejection. Remove the stacker
when using roll paper or Cut Sheet (1 sheet).
U “Attaching and Removing the Stacker (for Plain Paper)” on page 34
F B1 width paper support (SC-T5100 Series/SC-T5100N Series only)
For roll paper or cut sheet (1 sheet) equivalent to B1 width (718 to 738 mm) only, raise the B1 width paper
support before printing to prevent scung and soiling of the print surface.
U “Loading Roll Paper” on page 28
U “Loading Cut Sheet(1 sheet)” on page 37
G Edge guides
Slide these guides against the le and right edges of the paper loaded in the auto sheet feeder. It can prevent
paper from being fed skewed.
H Auto sheet feeder
is allows you to load multiple sheets of A3 to A4 cut sheet. e loaded paper is automatically fed and printed
continuously.
U “Loading Paper in the Auto Sheet Feeder” on page 34
I Cut sheet cover
Open this cover when using the auto sheet feeder or when loading a cut sheet of paper.
U “Loading Cut Sheet(1 sheet)” on page 37
When loading roll paper, open this cover and then open the roll paper cover.
To prevent dust from accumulating inside the printer, use the printer with this cover closed when not using the
auto sheet feeder and when not loading a cut sheet of paper.
J Front cover
Open this cover when replacing ink cartridges or clearing a paper jam.
SC-T5100 Series/SC-T3100 Series/SC-T5100N Series/SC-T3100N Series User's Guide
Introduction
8
