215239
96
Zoom out
Zoom in
Previous page
1/130
Next page
96 Solving Problems
Green
Flashing orange
It’s time to replace the lamp. See page 89 for instructions. If you continue
to use the lamp after the replacement warning, there is an increased
possibility that the lamp may break.
Green
Orange
No air filter. Make sure that the air filter is securely installed; see page 87.
If the error continues when the air filter is installed, there is a problem
with the air filter sensor. Stop using the projector, disconnect the power
cord, and contact Epson as described on page 106.
Green
Flashing orange
Low air flow. If you see a message saying that the air filter is clogged,
make sure that the air filter is clean. If it is clogged, clean it or replace it
with a new filter; see page 87.
Red
Flashing red
There is a problem with the fan or temperature sensor. Stop using the
projector, disconnect the power cable, and contact Epson as described
on page 106.
Red
Red
The projector is overheating, which turns the lamp off automatically. Wait
until the cooling fan stops, about five minutes, then unplug the power
cord. Plug the power cord back in and press the P Power button. Make
sure the room temperature is not above 95 °F (35 °C) and there is plenty
of space around and under the projector for ventilation.
The air filter may be clogged. Clean or replace it as described on page 87.
If the projector continues to overheat after you clean the air filter, the
problem may be caused by damage to the cooling fan or temperature
sensor. Contact Epson for help.
Warning: Except as specifically explained in this User’s Guide, do not
attempt to service this product yourself.
If you installed the optional Epson smoke filter in the projector, try the
following:
If you are using the projector at a high altitude (4,900 feet [1500
meters] or higher), set High Altitude Mode to On (see page 61).
You may need to set the Brightness Control to Low (see page 59).
Replace the smoke filter (see page 87).
If the error continues, stop using the projector, disconnect the power
cable from the electrical outlet, and contact Epson as described on
page 106.
Light Status Description
96


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Epson powerlite 6110i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Epson powerlite 6110i in the language / languages: English as an attachment in your email.

The manual is 3,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info