617846
10
Zoom out
Zoom in
Previous page
1/82
Next page
8
Take note of the following advice in order to prevent malfunction and damage.
Be sure to observe the operating temperatures
and storage temperatures given in this guide
when using and storing the projector.
Do not set up the unit in places where it might
be subjected to vibration or shock.
Do not install the unit close to television, radio or
video equipment that generates magnetic fields.
This may adversely affect the audio and images of
this unit, and may cause a malfunction. In the event
that such symptoms occur, move the unit further
away from any television, radio and video
equipment.
Do not operate the projector under any of the
following conditions. If this is not observed,
problems with operation or accidents may result.
Do not move this unit during playback.
This may damage the disc or cause malfunction.
Avoid using or storing this unit in cigarette or
other smoke filled places, or in rooms containing
a large amount of dust.
This may cause degradation of the image quality.
Do not touch the projection lens with your bare
hands.
If fingerprints or marks are left on the face of the
lens, the image will not be projected clearly. When
the unit is not in use, be sure to attach the lens cover.
EPSON will not be held responsible for damage
arising from projector or lamp failure outside the
range of that which is covered in your warranty
terms.
If you move this unit from a cold place into a warm
room, or, if the room in which this unit is installed is
heated rapidly, condensation (moisture) may form
internally or on the lens surface. If condensation forms,
it may not only cause incorrect operation such as
weakening of the image, but also damage the disc and/
or parts. In order to prevent against condensation, setup
this unit in the room approximately one hour before it is
to be used. If by some chance condensation does form,
disconnect the power cable from the outlet, then wait
one to two hours before use.
A mercury lamp with high internal pressure is used as
the unit’s light source.
The characteristics of the mercury lamp are:
The intensity of the lamp decreases with use.
When the lamp reaches the end of its life, it will no
longer light or may break with a loud noise.
The life of the lamp may vary greatly depending on
the individual lamp characteristics and the operating
environment. You should always have a spare lamp
ready in case it is needed.
Once the lamp replacement period has elapsed, the
possibility of lamp breakage incrcases. When the
lamp replacement message appears, replace the lamp
with a new one as soon as possible.
This product includes a lamp component that contains
mercury (Hg). Please consult your local regulations
regarding disposal or recycling.
Do not dispose of it with normal waste.
Use and Storage
Notes on handling and storage
While the projector is
standing on its end
While the projector is placed
with the top facing up
While the projector is
placed with the bottom up
While the projector is
tilted to either side
Condensation
Lamp
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Epson EMP-TWD10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Epson EMP-TWD10 in the language / languages: English as an attachment in your email.

The manual is 3,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Epson EMP-TWD10

Epson EMP-TWD10 User Manual - German - 85 pages

Epson EMP-TWD10 User Manual - Dutch - 82 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info