6486
44
Zoom out
Zoom in
Previous page
1/56
Next page
42
Maintenance
Replacing consumables
Replacing the air filter
Replacing the lamp
Resetting the lamp operating time
Turn off the power, wait
until the projector cools
down and the "beep
beep" tone sounds, then
disconnect the power
cable.
Remove the air filter
cover.
Put your finger under the latch
and pull it upward.
Dispose of used air
filters properly in
accordance with your
local regulations.
Air Filter:
Polypropylene
TIP
Turn off the power, wait
until the projector cools
down and the "beep
beep" tone sounds, then
disconnect the power
cable.
* Wait until the lamp cools
down (takes
approximately 1 hour).
Remove the lamp cover.
To remove the cover, use a
screwdriver (the one supplied in
the same package as the
optional lamp) inserted into the
lamp cover open switch.
Securely tighten the
lamp fixing screws.
Install the lamp cover.
If the lamp stops working
and needs to be
replaced, there is the
danger that the lamp
may already be broken.
If replacing the lamp of a
projector which has been
installed to the ceiling,
you should always
assume that the lamp is
broken and handle it with
extreme care during
removal. Furthermore,
you should stand to the
side of the projector, not
underneath it.
Press to turn on
the power.
Press to display the
configuration menu.
The lamp operating time
must always be reset after
the lamp has been replaced
with a new one.
The projector has a built-in
counter which keeps track
of the lamp operating time.
When the cumulative
operating time reaches a
certain point, it causes the
replacement warning
message to be displayed.
44


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Epson EMP-TW20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Epson EMP-TW20 in the language / languages: English as an attachment in your email.

The manual is 2,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Epson EMP-TW20

Epson EMP-TW20 User Manual - German - 56 pages

Epson EMP-TW20 User Manual - Dutch - 54 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info