6466
96
Zoom out
Zoom in
Previous page
1/118
Next page
94
Caution :
If the lamp stops working and needs to be replaced, there is the danger that the lamp
may break when handled.
If replacing the lamp of a projector which has been installed to the ceiling, you should
always assume that the lamp is broken and handle it with extreme care during removal.
Furthermore, you should stand to the side of the projector, not underneath it.
Procedure
1
Turn off the projector power, wait
for the cool-down
period to end,
and then disconnect the power
cord.
The cool-down period lasts for about 2
minutes. The actual time will vary
depending on the external air temperature.
2
Wait until the lamp has cooled
down, and then remove the lamp
cover.
It takes approximately 30 minutes for the
lamp to cool down by itself.
Use the screwdriver that is provided with
the replacement lamp to slide the lamp
cover opening switch so that the lamp
cover lifts up. Hold the raised section of
the lamp cover and then slide it forward to
remove it from the projector.
3
Loosen the two lamp fixing screws.
Use the screwdriver that is supplied with
the replacement lamp to loosen the two
lamp fixing screws that are securing the
lamp to the projector.
Replacing the Lamp
Maintenance
96


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Epson EMP-810 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Epson EMP-810 in the language / languages: English as an attachment in your email.

The manual is 4,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info