6466
47
Zoom out
Zoom in
Previous page
1/118
Next page
45
Tip :
• When keystone correction is carried out, the projected image will become smaller.
• Procedure to follow if using both horizontal and vertical keystone correction:
1. With the front adjustable foot retracted, set the projector so that it is fully horizontal.
2. Extend the front adjustable foot to adjust the angle as necessary.
3. Adjust the vertical keystone distortion until both sides of the picture are vertical.
4. Adjust the horizontal keystone distortion until the top and bottom edges of the
picture are both horizontal.
• The keystone correction settings are memorized, so that if you change the position or
angle of the projector, you may need to readjust the keystone correction settings.
To return a previous keystone correction to the initial setting, carry out the following
operations.
To initalize vertical keystone correction: While holding down the [Sync +] button,
press the [Sync -] button for 1 second or more.
To initalize horizontal keystone correction: While holding down the [Tracking +]
button, press the [Tracking -] button for 1 second or more.
• If the images become uneven in appearance after keystone correction is carried out,
decrease the Sharpness setting. (P.63)
• Keystone correction can also be carried out using the projector setting menu. (P.69)
• If you carry out both horizontal and vertical keystone correction, the correction range
will become smaller than it would be if only one type of correction was carried out.
• If the value displayed in the gauge on the screen stops changing when horizontal or
vertical keystone correction is being carried out, it indicates that the limit for
horizontal or vertical keystone correction has been exceeded. Check that the projector
has not been set up at an angle which exceeds the proper limit.
• If either the E-Zoom, Effects or P in P functions are used at the same time as horizontal
or vertical keystone correction has been carried out, a message may appear on the
screen if these functions are used when the keystone correction amount is near the
limit. It may not be possible to use the E-Zoom, Effects or P in P functions if this
happens. In such cases, re-adjust the projector position so that the amount of keystone
correction required is reduced.
• The limit value for keystone correction will vary depending on the video signal being
input.
47


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Epson EMP-810 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Epson EMP-810 in the language / languages: English as an attachment in your email.

The manual is 4,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info