214749
128
Zoom out
Zoom in
Previous page
1/165
Next page
127
Problem Solving
User’s Guide
The remote control does not work
The fans do not stop when power is turned off
Check Remedy
Is the [R/C] switch at the "ON" position? Set the [R/C] switch to the "ON" position. p.36
Is the remote control light-emitting area
facing towards the remote control light-
receiving area when it is operated?
Face the remote control towards the remote control light-receiving area.
The operating angle for the remote control is approximately ±30º horizontally and approximately
±15º vertically. p.14
Is the remote control too far from the
projector?
The operating range for the remote control is approximately 10 m. p.14
If operating the remote control from a distance or if you would like to ensure that remote control
operations work properly, use the optional remote control cable kit. p.151
Is direct sunlight or strong light from
fluorescent lamps shining onto the remote
control light-receiving area?
Set the projector up in a location where strong light will not shine onto the remote control light-
receiving area.
Are the batteries dead, or have the batteries
been inserted correctly?
Insert new batteries, while making sure that they face correctly. p.12
Does the remote control's ID number match
the projector's ID number?
If the remote control's ID number is set to a number other than "0", the ID number must match the
projector's ID number, otherwise the remote control will not work. p.74
Is the remote control cable still connected to
the [Remote] port of either the remote control
or the projector?
If the remote control cable is still connected to the [Remote] port, the remote control light-receiving
areas of the projector or the remote control light-emitting area of the remote control will not work. If
not using the remote control cable kit, disconnect the remote control cable from the [Remote] port of
either the remote control or the projector.
Check Remedy
Is the "Standby Mode" configuration menu set
to "Network ON"?
If the menu is set to "Network ON", the fans will continue to operate after the cool-down period has
finished.
"Advanced1" - "Standby Mode" p.91
128


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Epson emp 7950nl at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Epson emp 7950nl in the language / languages: English as an attachment in your email.

The manual is 9,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info