737380
275
Zoom out
Zoom in
Previous page
1/312
Next page
Solving Projector or Remote Control Operation Problems
275
Check the solutions in these sections if you have problems operating the
projector or remote control.
gg Related Links
• "Solutions to Projector Power or Shut-Off Problems" p.275
• "Solutions to Problems with the Remote Control" p.275
• "Solutions to Password Problems" p.276
• "Solution When "The Battery that Saves Your Clock Settings is Running
Low" Message Appears" p.276
Solutions to Projector Power or Shut-Off Problems
If the projector does not turn on when you press the power button or it turns
off unexpectedly, try the following solutions:
• Make sure the power cord is securely connected to the projector and to a
working electrical outlet.
• If the power button on the remote control does not turn on the projector,
check its batteries and make sure at least one of the remote receivers are
available in the Remote Receiver setting in the projector's Installation
menu.
• The projector's buttons may be locked for security. Unlock the buttons in
the Control Panel Lock setting in the projector's Management menu or use
the remote control to turn on the projector.
• If the projector's light source turns off unexpectedly, it may have entered
sleep mode after a period of inactivity. Perform any operation to wake the
projector. To turn off sleep mode, set the Sleep Mode setting to Off in the
projector's Operation menu.
• If the projector's light source turns off unexpectedly, the A/V mute timer
may be enabled. Set the A/V Mute Timer setting to Off in the projector's
Operation menu.
• If the projector's light source turns off, the status indicator is flashing, and
the temp (temperature) indicator is lit, the projector has overheated and
turned off.
• The cooling fans may run in standby status depending on the projector
settings. Also, when the projector wakes from standby status, the fans may
cause an unexpected noise. This is not a malfunction.
• The power cord may be defective. Disconnect the cord and contact Epson
for help.
gg Related Links
• "Projector Administration Settings - Management Menu" p.226
• "Projector Feature Settings - Operation Menu" p.224
• "Projector Installation Settings - Installation Menu" p.220
• "Unlocking the Projector's Buttons" p.165
Solutions to Problems with the Remote Control
If the projector does not respond to remote control commands, try the
following solutions:
• Check that the remote control batteries are installed correctly and have
power. If necessary, replace the batteries.
• Make sure you are operating the remote control within the reception angle
and range of the projector.
• Make sure the projector is not warming up or shutting down.
• Check to see if a button on the remote control is stuck down, causing it to
enter sleep mode. Release the button to wake the remote control up.
• Strong fluorescent lighting, direct sunlight, or infrared device signals may be
interfering with the projector's remote receivers. Dim the lights or move the
projector away from the sun or interfering equipment.
• Make sure at least one of the remote receivers are available in the Remote
Receiver setting in the projector's Installation menu.
• If the Remote Receiver setting is disabled, hold down the [Menu] button on
the remote control for at least 15 seconds to reset the setting to its default.
• If you assigned an ID number to the projector to operate multiple projectors
from the remote control, you may need to check or change the ID setting.
275


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Epson EB-725Wi at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Epson EB-725Wi in the language / languages: English as an attachment in your email.

The manual is 8,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Epson EB-725Wi

Epson EB-725Wi User Manual - German - 325 pages

Epson EB-725Wi User Manual - Dutch - 324 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info