Manual Entrematic Superior 42 TOR (page 4 of 24) (All languages)

680497

Zoom out

Zoom in

1/24

The door opening and garage floor should be finished

before installing the garage door.

Always place the door sections on suitable packing (such

as clean cardboard) to prevent damage to the door sur-

faces.

Ensure you have all the tools you require to install this

door inside the garage before you begin the installation.

Ensure you have adequate lighting within the garage to

complete the installation

ATTENTION

To ensure the correct operation of the door, please note the

following:

1. Read and follow these instructions thoroughly:

2. It is important to make a accurate installation of the

wall-tracks. If necessary prepare the walls prior to

installation so to achieve a square and level opening.

This will allow for the correct vertical and horizontal

measurements on all sides.. See points 3 – 5.

3. All hinges must be correctly installed so to prevent any

risk to personal safety. Note fixing position of hinge

part into the panel. The lubrication hole must be visible.

See point 18.

4. Cross measure ceiling track corners, and if necessary

adjust to have the x-measurements equal. See point 10.

5. When TOF (Torsion front balancing) be sure to

exchange the screw and put on the plastic guide, for

left and right top-roller. See point 19:1 in the illustra-

tion plan. This to avoid the door-cable from hitting the

track.

WORK SpACE

pACKAGING

Recyclable materials are used for the packaging supplied

with this door. Please dispose of packaging materials in

accordance with your relevant national regulations.

To open the door from inside, release the latch at the lock.

Then pull the lower rope simultaneously to lift the door

The door can be locked from the inside by the lock button

(see

installation manual sketches page 22).

If the button is in locked position when the door is closed,

the door cannot be opened from the outside without first

unlocking with the key.

To open the door from outside, use the handle and pull up

the door.

To close the door from the inside, pull the door down by

firstly pulling the lower rope and then pull upper rope. Let

the latch fall into locked position.

To close the door from outside, first pull the lower rope

until the outside handle can be reached, then use the han-

dle to close the door.

HANDLING MANuAL DOOR

For your safety, ensure you use only genuine manufacturer

supplied spare parts. Failure to do so can endanger your

safety and will invalidate the guarantee. For spare parts

and/or service, first contact the installer of this door. When

in need of replacement parts, please refer to the door

number stated on the identification sticker placed on the

upper part inside of the right hand track.

SpARE pARTS

• Every 6 months

Check

the condition of the door cables and replace

them if damaged.

Check the integrity of the fixtures to the wall, ceiling

and floor. Re-secure if necessary

To preserve the appearance of the door, clean the door

sections using a soft sponge and normal car shampoo.

Rinse thoroughly with clean, cold water.

Do not use corrosive or solvent-based cleaners or

materials that may scratch the door.

• Every 12 months

Clean the rubber seals, and lightly coat the top- and

bottom-sealing with Vaseline or similar product.

Lubricate the hinges and plastic bearings with standard

household lubricating oil.

• Every 4 years

Apply lubricating oil to the spring-holder bearing seat

of the torsion shaft.

CARE & MAINTENANCE

• After 20 000 door operations

orsion springs will require replacement by qualified

personnel after approximately 10 years, based on an

average of 5-6 door cycles per day.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Entrematic Superior 42 TOR in the language / languages: All languages as an attachment in your email.

The manual is 4,81 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Entrematic Superior 42 TOR Manual

Product: