807497
55
Zoom out
Zoom in
Previous page
1/76
Next page
ENDURO® EM515FL 45
Ref: EM515FL-UM-TKI-0323-Rev.B.
After manoeuvring, deactivate the manoeuvring system by moving the slide switch of the remote handset (Fig.
8A) down (Position “0”). The communication icons on the remote handset will turn off. Store remote handset in
a safe place (out of reach of children or other unauthorised people).
Turn off the battery power isolation switch.
Before you start driving always make sure that the both drive units are fully disengaged!
OPERATION FINDING LEVEL
It is possible to completely level the caravan with the manoeuvring system and autoSteady system.
First of all, it is important that the caravan is skewed within the set specifications:
Make sure that the caravan tilts a few degrees forward, possibly turning the nose wheel slightly in.
Make sure that the caravan on the axle does not tilt too much to one side. The maximum height difference
between the left and right wheel may not exceed 10cm (for a caravan with a width of 230cm).
When activating the “finding level function” but having the caravan tilting too much to one side (on the axle),
the remote handset will give an optical signal and the leveling system (Fig. 8O) will indicate which side of the
caravan is too low. The Finding Level function will not start and also the Finding Level icon (Fig. 8S) will not
light up.
If the caravan is almost in place, press the FL button (Fig. 8T) on the remote handset during at least three
seconds (every second there will be a beep). If the caravan is misaligned within the specified specifications, the
Finding Level icon (Fig. 8S) will light up continuously. The system is ready to continue.
Place the wedge / leveler (not supplied) on the front or on the back of the wheel which is lowest (Fig. 15, 16).
Now you can choose the movements according the symbols shown on the remote handset. Straight forward
(Fig. 13B) or straight reverse (Fig. 13C) or possibly left forward (Fig. 13D), left reverse (Fig. 13F), right forward
(Fig. 13E), right reverse (Fig. 13G).
As soon as the caravan is level in the width direction (on the axle (Fig. 17)), the manoeuvring system will stop
automatically and the remote handset will give a buzzer.
NOTE: The Finding Level system only stops if the caravan is level in the width direction (on
the axle). If the ramp/leveler used is not high enough, or if a different situation arises, the
caravan may run over the ramp/leveler. Make sure you release the remote control buttons
in time!
If the manoeuvring system is extended with the autoSteady system, then the corner steadies will also be
automatically turned out (Fig. 18) and the caravan will also be levelled automatically in the longitudinal
direction. However, it is very important that the caravan tilts a few degrees (front of caravan a little down),
otherwise the system will stop and the remote handset will give an optical message and the waterlevel display
will blink.
If this situation occurs, turn the nose wheel slightly in and again go through the Finding Level process (press
the FL button). Since the caravan is already level at the axle, and thus the corner steadies will turn out.
If the caravan is tilted for a few degrees, the front corner steadies will be automatically turned out, and the
caravan will be leveled in the longitudinal direction. Then the rear corner steadies will be turned out. Finally, all
corner steadies will shortly be turned out (short boost) to stabilize the caravan.
As soon as the caravan is level and stable, the remote control will give a buzzer (2 beeps) and the Finding Level
icon will go off.
When you are ready with manoeuvring you need to secure the handbrake.
If necessary, place a "counter- keg/leveller" behind the wheel on the keg/leveller to prevent rollback (Fig. 19).
Press at the same time, during at least three seconds, the two buttons for disengaging the motor powered
rollers (Fig. 8J). The disengaging icon (Fig. 8P) will blink fast during these three seconds and every second
there will be a beep. This warns you that the system will be activated!
After these three seconds the motor powered rollers will be released from the tyre and the disengaging icon will
illuminate constant, now you can release the two buttons. When the motor powered rollers are completely
disengaged you hear a short beep, the disengaging icon will switch off and the system is ready for transport.
After manoeuvring, deactivate the manoeuvring system by moving the slide switch of the remote handset (Fig.
8A) down (Position “0”). The remote handset screen will turn off. Store remote handset in a safe place (out of
reach of children or other unauthorised people).
55


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Enduro EM515FL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Enduro EM515FL in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 38.02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info