807499

Enduro EM313A Manual

41
Zoom out
Zoom in
Previous page
1/60
Next page
ENDURO® EM313A 34
Ref: EM313A-UM-TKI-0323-Rev.B.
OPERATION – MOTOR UNITS
The manoeuvring system has two motor units (1 & 2). In general they are mounted in front of the axle of the
caravan. Both units are identical but cannot be switched.
Figure 5.1
A. Aluminium drive roller
B. Gearbox
C. Plastic motorcover
D. Driving motor (in housing)
E. Motor for automatic engaging system (in housing)
F. Traction indicator label
Traction indicator label:
The yellow-green-red traction indicator label (Fig. 5.1F), on the side of each motor unit indicates if the roller is
depressing the tyre sufficiently to provide adequate traction.
If the pointer is in the yellow area – Rollers are not touching or depressing the tyre sufficiently.
If the pointer is in the green area – Rollers should be connecting correctly to the tyre (margin of 15mm).
If the pointer is in the red area – Rollers are connected to the tyre but in an extreme position. It could be
that the tyre of the caravan has insufficient air pressure or the drive unit has been knocked out of position
and a visit to a workshop is required to reposition the assembly.
Disconnect the motor powered rollers in case of emergency:
In the case that the caravan battery is discharged too far to automatically take of the motor powered rollers of
the tyre, or there is a defect, you can also do this manually.
Open the plastic cap (Fig. 5.2A) at the rear side of the housing of the motor for the automatic engaging system.
If necessary use a screwdriver. Place the emergency key (39) on the emergency socket in the motor unit (Fig.
5.3B) and turn it until the motor unit including motor powered rollers are in the beginning position. Repeat this
also on the motor unit on the other side.
Close the plastic caps on the motor housing.
As soon as the battery is charged again, or the problem is solved, the motor powered rollers automatically work
again.
OPERATION – REMOTE HANDSET
The remote handset (9) is powered by three AAA 1.5 Volt batteries, and is activated by moving the slide switch
to “On”-I (Fig. 8A). Once activated the communication icon (Fig. 8H) will illuminate and the directional controls
can now be used.
Figure 8
A. Slide switch (“Off” –O and “On”-I)
B. Caravan forwards (both wheels rotate in forwards direction)
C. Caravan reverse (both wheels rotate in reverse direction)
D. Caravan left forwards (right wheel rotates in forwards direction)
E. Caravan right forwards (left wheel rotates in forwards direction)
F. Caravan left reverse (right wheel rotates in reverse direction)
G. Caravan right reverse (left wheel rotates in reverse direction)
H. Communication icon: reflects status of the remote handset and caravan manoeuvring system
I. Overload icon: Amp overload protection is activated, wait about 60 seconds and try again
J. Remote battery icon: the 1.5 Volt batteries of the remote handset are nearly empty
K. Caravan battery voltage icon: Caravan battery voltage too low or too high
L. Two handed service for automatic engaging of the motor powered rollers to the tyre
M. Two handed service for automatic disengaging of the motor powered rollers from the tyre
N. Engaging icon: reflects status of the automatic engaging system
O. Disengaging icon: reflects status of the automatic disengaging system
When you drive straight forwards or reverse (press button B or C), it is also possible to adjust the direction by
additional pressing button D or E (when driving forwards) or button F or G (when driving reverse).
In addition, the ‘right forward’ (E) and ‘left reverse’ (F) buttons or ‘left forward’ (D) and ‘right reverse’ (G)
buttons may be pressed at the same time to turn the caravan around on its own axis without moving forward or
backward (this function just can work under the “single-axle function”).
When you switch within 2 seconds from forward driving to reverse driving (and the other way around), a small
delay of 1 second will appear to protect the electronics and the motors.
… 41 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Enduro EM313A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Enduro EM313A in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2.23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info