Manual Enduro EM303 plus (page 43 of 60) (English, German, Dutch, French)

722065

Zoom out

Zoom in

1/60

ENDURO

EM303

Ref: EM303

-UM-TKI-0119-Rev.A.

OPERATION – HITCHING AND UNHITCHING

It is possible to position the caravan’s hitch exactly over a stationery car’s tow ball using the manoeuvring

system. But please be very careful!

Use the button controls on the remote handset to bring the hitch of the caravan to the car. The soft start

technology allows you to locate the tow-ball of the car by centimetre. It is better reach the tow ball with several

short “trips” rather than trying to do it in one “trip”.

WARNING: When the buttons on the remote handset are released, the caravan will slowly

stop after 0.5 second and continue to move about 6cm (depending on final speed). When

the buttons of the remote handset are released when the system is still in the “soft start”

stage (slowly speed up), the caravan will stop immediately.

When the hitch is right above the tow ball of the vehicle, lower the hitch to the ball and engage in the normal

way using the jockey wheel.

Release the rollers from the caravan’s tyres. You cannot tow the caravan with the drive

units are engaged! Before you start driving always make sure that the both motor units are

fully disengaged!

Trying to drive away with the motor units still engaged, will damage the manoeuvring

system, your caravan tyres and strain your tow vehicle!

MAINTENANCE

To prevent the battery from becoming totally discharged during long periods of inactivity it must be

disconnected, fully charged and frost-proof stored.

Please check regularly that the rollers of the motor units are free of any dirt, or debris that may have been

picked up from the road.

Regularly clean the motor units with a water hose to dissolve mud etc.

Please check regularly the distance between the rollers and the tyres. In the neutral (fully disengaged) position

this must be about 20mm.

Once a year have your caravan manoeuvring system maintained and visually inspected. This inspection must

include all the bolt/nut connections, the cables and electrical connections and lubrication of movable

parts/joints.

In case of any failure or problem, please contact your ENDURO

supplier.

TROUBLE SHOOTING

Should your manoeuvring system fail to operate, please check the following:

System fails to operate, does not function at all:

Make sure that the battery power isolation switch (29) is turned on.

Check the cable-connection between the caravan battery and the control unit.

Check the fuse (Fig. 6) in the red positive battery cable. If the fuse is blown, it must be replaced with a fuse of

the same value (80A). Never “bridge” the fuse (if needed contact your ENDURO

supplier). To replace the fuse,

first disconnect the positive (+) power cable from the battery. Than release the mounting screws that hold the

fuse (Fig. 6A), replace the fuse (Fig. 6B), and finally tighten the screws securely. Close the housing of the fuse

and connect the positive (+) power cable again to the battery. The system is ready again for use.

Check the battery of the remote handset. If empty, renew the 9 Volt battery.

Caravan battery could be empty. If empty, recharge completely or renew caravan battery before taking any

further action.

Caravan battery could be overloaded. Check your charging equipment and try to discharge the battery by

connecting/using a light or any other load. If this does not give any result, renew caravan battery before taking

any further action.

Check the distance between the remote handset and the caravan is not more than 5 metres. If there is no

signal between the remote handset and the control unit, the manoeuvring system will not function at all and

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Enduro EM303 plus in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 9,63 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Enduro EM303 plus Manual

Product: