Manual Emtec Movie Cube F200 (page 13 of 13) (English)

473777

Zoom out

Zoom in

1/13

F200 User Guide

Q: Is static IP setup for F200 required?

A: Since the F200 renegotiates the UPnP port forwarding rules whenever it gets an IP address, it should not

need to have a static IP set if your router supports UPnP (and if UPnP is enabled). However, there is no harm in

having the IP set for static either – just the standard warnings about making sure that the static IP chosen is not

in the DHCP allocation range set by the router or used by another device using static IP on the same LAN.

If the F200 is being used on a router that does NOT support UPnP, and as a result port forwarding had to be set

manually using the router’s web interface, then a static IP assignment for the F200 is recommended. Some

routers feature a way to assign the same IP address to a device repeatedly, which can be used instead of

setting static IP on the F200.

This can be called (depending on the router):

• DHCP reservation

• Static DHCP

• Reserved IP address

and requires you to enter both the IP address you wish to use and the Mac address of the device in question

(F200). See your router’s documentation for more information on this feature.

Q: IR code learning fails or is ok but fails to control the STB

A: Place the remote control around 5cm away from the IR lens of the F200 during the IR code learning. Try to

press and hold the button of the remote control during the IR code learning until the Setup Wizard detects the

IR key. Select “Verify” to confirm the IR key learned is correct and can control the external device.

Otherwise, redo the IR code learning of this key again.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Emtec Movie Cube F200 in the language / languages: English as an attachment in your email.

The manual is 0,87 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Emtec Movie Cube F200 Manual

Product: