682508
30
Zoom out
Zoom in
Previous page
1/44
Next page
26
Buttonhole
stitching
Buttonholes are sewn from the front of the
presser foot to the back, as shown.
Raise the presser foot and cut thread. When raise
the presser foot, the needle will return to original
position in order to sew over same buttonhole.
After sewing the buttonhole stitch, raise the
buttonhole lever until it stops.
Cut the center of the buttonhole being careful not
to cut any stitches on either side. Use a pin as a
stopper at the bar tack so you do not cut too
much.
Making a buttonhole on stretch
fabrics
When sewing buttonholes on stretch fabric, hook
heavy thread or cord under the button-hole foot.
Attach the buttonhole foot and hook the gimp
thread onto the back of the presser foot.
Bring the two cord thread ends to the front of the
foot and insert them into the grooves, then
temporarily tie them there. Lower the presser
foot and start sewing.
Set the stitch width to match the diameter of the
gimp thread.
Once sewing is completed, pull the gimp thread
gently to remove any slack, then trim off any
excess.
Please note: It is suggested that you use
interfacing on the backside of the fabric.
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Empisal EES10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Empisal EES10 in the language / languages: English as an attachment in your email.

The manual is 4,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info