682508
13
Zoom out
Zoom in
Previous page
1/44
Next page
Threading
the upper
thr
ead
6
5
7
8
Please Note: It is important to carry out the threading correctly as by not doing so several sewing
problems could
r
esult.
Start by raising the needle to its highest point, and also raise the presser foot to
r
elease the
tension
discs.
1. Lift up the spool pin. Place the spool of thread on the spool pin so
that the thread comes from the front of the spool, then place the spool
cap at the end of the spool pin.
2. Draw the thread from the spool through the upper thread guide.
3. Guide the thread around the thread guide pulling the
thread through the pre-tension spring as illustrated.
4. Thread the tension module by passing the thread between the
silver discs.
5. Then, down and around the check spring holder.
6. At the top of this movement, pass the thread from right to the left
through the slotted eye of the take-up lever and then downwards
again.
7. Pass the thread behind the flat, horizontal thread guide.
Guide the thread through the wire loop.
Pull the end of the thread through the needle from front to rear,
and pull out about 10 cm of thread.
Use the needle threader to thread the needle. (On the next page)
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Empisal EES10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Empisal EES10 in the language / languages: English as an attachment in your email.

The manual is 4,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info