682506

Empisal Companion 7D Manual

24
Zoom out
Zoom in
Previous page
1/32
Next page
- 23 -
ROLLED AND NARROW EDGE
To carry out either of the above sewing tasks proceed as follows.
(1) Refer to page 22 for special foot position setting.
(2) Turn the handwheel toward you until needles are fully raised.
(3) Open front cover and remover left needle. See page 19.
(4) Set stitch length between 1.0-2.0 mm. See page 17. Also ensure that differential control is set at
'N' position.
(5) Adjust stitch width, as shown on page 18.
(6) If not already threaded re-thread the machine.
(7) Place fabric under presser foot and start to sew.
Always test the stitch and tension settings on scrap fabric before sewing on an actual garment.
When either Rolled or Narrow hemming, we recommend you change the threads as shown on
page 24.
ALWAYS remember to re-set the special foot for normal serging after you have finished your rolled
edge procedure.
[ ROLLED EDGE ]
With a rolled edge the loops formed by the
upper looper thread should be pulled to the
underside of the fabric. This is done by setting
the tensions as shown on page 24.
[ NARROW EDGE ]
For seams on sheer or lightweight fabrics, set
tensions as shown on page 24 for a balanced
tension.
Lower looper
thread
Back
Upper looper
thread
1.0~3.0 mm
Needle thread
Back
Upper looper
thread
Needle thread
Front
Lower looper
thread
Front
1.0~3.0 mm
… 24 …


Need help? Post your question in this forum.

Forumrules
1

Forum

empisal-companion-7d

Reset search

  • The tread is correctly inserted. The stitching does not form correctly. I think that the syncronising might be incorrect. May I have a video that shows the detail of the syncronising of the needle and the bloopers, while stitching? Submitted on 3-1-2024 at 10:09

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Empisal Companion 7D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Empisal Companion 7D in the language / languages: English as an attachment in your email.

The manual is 0,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info