691899
6
Zoom out
Zoom in
Previous page
1/13
Next page
5/12 EmpirBus NXT SP-12 User manual Ver 1.23
4.3!Terminal!resistor!switches!
The SP-12 has onboard terminal resistors that can be connected to the bus using switches located
beneath button 5 on a horizontal panel and under button 8 on a vertical panel. See figure 4.1, 5.1
and 5.2 for position of the switch.
The switch is on as it is pushed towards on, and off as it is pushed towards the numbers. Switch 1 and
2 will individually add 120 Ω to the CAN bus Switch 3 will add 1 kΩ to the LIN bus.
The NMEA2000 requires a total resistance of the bus of 60Ω which is achieved by two parallel 120
resistors. If the SP-12 panel is placed within 6 meters from the end of the bus, an internal terminal
resistor in the SP-12 can be used to exclude one external terminal resistor.
If the total bus length is shorter than 6 meters, both external terminal resistors can be excluded by
using both of the internal terminal resistors in the SP-12.
ON .
1 2 3.
Figure 4.2: Internal terminal resistor switches
Figure 4.4: Bus example with total bus length less than 6 meter
Bus power feed
SP-12 with terminal
resistor switch 1
and 2 switched on
DCM-11
MCU-11
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for EmpirBus NXT SP-12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of EmpirBus NXT SP-12 in the language / languages: English as an attachment in your email.

The manual is 1,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info