9/15 EmpirBus NXT DCM User manual Ver 1.53
7.3.2!Manual!override!switch!on!
1. Press the right arrow button. ”SEL” will be shown in the display.
2. Use the right arrow button to step to the desired channel.
3. Press and hold MAN ON/MAN OFF for three seconds
4. If the channel indicator still is flashing red, again press and hold MAN ON/MAN OFF for three
seconds
5. Press the left arrow until the message “SEL” in the display disappears.
6. Outputs manually switched off are now indicated with flashing green indication.
7.3.3!Resetting!a!channel!
1. Press the right arrow button. ”SEL” will be shown in the display.
2. Use the right arrow button to step to the desired channel.
3. Press and hold RESET/AUTO for two seconds. The channel is now reset.
4. Press the left arrow until the message “SEL” in the display disappears.
7.4!Wireless!transmitter!pairing!
If the DCM is equipped with a wireless receiver, the transmitters (switches/remotes/detectors etc.)
need to be paired with the unit in order to operate. Each transmitter needs to be paired to a unique
function number.
1. Press and hold MAN ON/MAN OFF for 10 seconds until the display shows “P00”.
2. Use right arrow button to step to “P10” for wireless receiver programming.
3. Press MAN ON/MAN OFF Once. Display shows “OAS” / “001” blinking. Wireless channel 1 is
selected.
4. Use right arrow button to choose channel (if other than 1).
5. Press MAN ON/MAN OFF to enter learning mode. Display flashes “LEA”.
6. Press the wireless switch (or trigger the detector) that is to be connected.
7. When button has been pressed the display alternates between “LEA” and “ACC” for five
seconds to indicate that the transmitter was learned and accepted.
8. The DCM auto detects the type of transmission from the transmitter and suggests a setting:
“FU1” or “FU2”. (FU1 = transmitter sends “pressed” and “released”, FU2 = transmitter sends
only “pressed”.)
Press MAN ON/MAN OFF to accept the setting and continue. If additional transmitters need
to be paired, repeat from step 3.
9. Press RESET/AUTO to exit programming mode and return to normal mode.
How to delete a paired wireless channel:
• Enter the programming mode P10 as mentioned above from point 1 to 3.
• Use right arrow key to select the channel you want to erase (1 to 30 ).
• Press MAN ON/MAN OFF once to enter learning mode.
• Press and hold in MAN ON/MAN OFF (the text “ddd” will appear on the display) until is
shows “del” then release the button.
• Press MAN ON/MAN OFF once, the text “dcd” on the display then confirm that the channel is
erased.
