691900
7
Zoom out
Zoom in
Previous page
1/16
Next page
EmpirBus NXT DCM User manual Ver 1.53 6/15
6.1.5!Analog!input!–!voltage!
Connect the voltage source directly to the desired channel. See data sheet for measuring range.
NOTE: The input signal source and the DCM must have common ground.
If input signal source is powered by another power supply, a resistor must be connected in series to
the input. A 10kΩ resistor is recommended for this purpose. The programming must take this in
consideration. NOTE: The power supply for the input signal source and the DCM must have
common ground. (I.e. Both batteries must have common ground.)
Input value x (15kΩ / (15kΩ + R) = measured value
!
6.1.6!Analog!input!–!multi!switch!
The circuit below enables four separate momentary switches to be connected to a single input
channel. Note: Multi switch channel setting is only possible for momentary switches. Only one
button can be pressed at a time.
6.2!Outputs!
Depending on the model, certain channels can be configured to be outputs. See the table 9.1 for
model specification.
6.2.1!Digital!output!–!positive!
Connect the load directly between the desired channel and minus.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for EmpirBus NXT DCM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of EmpirBus NXT DCM in the language / languages: English as an attachment in your email.

The manual is 1,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info