167608
9
Zoom out
Zoom in
Previous page
1/20
Next page
9
4.2 RCA & REMOTE WIRES
Carefully run the audio signal interconnects and the remote wire and from the head-unit to the ampli-
fier. As mentioned before, the audio signal cables should always be routed completely separate from
the power cables. Connect the remote (turn on/turn off) lead to the respective input terminal of the
amplifier and to the remote output of your head-unit. Now you can connect the RCA interconnects to
the respective outputs of your head-unit and to the inputs of the amplifier. Pay attention to connect the
stereo interconnects correspondingly,
left is 1CH, right is always 2CH a.s.o.
4.3 LOUDSPEAKER WIRES
Once the speaker cables have been routed, turn loose the screws of the speaker terminal binding posts
and – after inserting the stripped speaker cables – re-tighten the screws. When baring wires for con-
nection, remove approximately 6-8mm of the insulation and after axially twisting the wires, insert the
bare ends into the corresponding speaker terminal output on the amplifier. Maintain
correct pola-
rity („“ to „“; „“ to „“).
5. INPUT LEVEL ADJUSTMENT
To reach a maximum in dynamic response from each individual head-unit/amplifier/speaker combi-
nation, it is important to set the respective input level controls („GAIN“) of all channel pairs correctly.
Before you start, you MUST set all tone controls (Bass, Mid, Treble, Loudness etc.) and the fader
on the head unit to their neutral or center positions.
Now turn all input gain controls of the installed amplifiers anti-clockwise to their minimum positions
and start with the channel pair, that drives the subwoofer system.
SUBWOOFER CHANNEL
Set the volume control of your head-unit to approximately 3/4 of full volume, while playing a dyna-
mic piece of music. Slowly increase the input gain control of the channel pair, that drives the subwo-
ofer(s), by turning the GAIN control clockwise until you can just about hear distorted sounds coming
out of your subwoofer system. Reduce the main volume level on your head-unit to a medium listening
level.
SATELLITE CHANNELS
Slowly increase the input gain control of the channel pair, that drives the loudspeaker system installed
in the front doors, by turning the GAIN potentiometer of the 1/2-CH section clockwise, until you reach
a good tonal balance with a slight emphasis of the bass range. Aim at a full bodied bass response.
Now slowly turn up the input GAIN control potentiometers of all the remaining channel pairs - until
you reach a good tonal balance of all speakers installed in your vehicle.
EM 7-CH Manual 2003 03.06.2003 11:14 Uhr Seite 9
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Emphaser ea 650 200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Emphaser ea 650 200 in the language / languages: English, German as an attachment in your email.

The manual is 0,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info