168847
12
Zoom out
Zoom in
Previous page
1/28
Next page
12
5. CROSSOVER ADJUSTMENTS
5.1 LOWPASS CROSSOVER FREQUENCY ADJUSTMENT
Note: Before you attempt to adjust the lowpass crossover frequency, you must set the subsonic highpass
filter to its lowest position (10 Hz).
The LOWPASS cut-off frequency setting depends on some variables. As a rule of thumb, settings in
a range between 60 to 90 Hz will render best sonic results. If you use this amp for SPL scores, it is
advisable to set the lowpass crossover frequency above 80Hz.
Note: In general, setting the lowpass crossover frequency too low, will result in a weak and muddy
sounding bass, while setting this crossover frequency too high will result in a ‘booming’ bass sound
and reduced low end extension.
5.2 SUBSONIC HIGHPASS CROSSOVER FREQUENCY ADJUSTMENT
Adjust the SUBSONIC potentiometer according to your needs. This setting depends on the dimension
and the power handling of the installed subwoofer system. The higher the subsonic crossover frequen-
cy is set, the higher the mechanical power handling of the connected subwoofer system will be. The
trade-off is reduced low end extension! The subsonic highpass can not be bypassed! But you can set
the SUBSONIC control to its lowest position at 10 Hz, which will not longer impose an audible effect
to the music played.
5.3 INPUT LEVEL ADJUSTMENT
To reach a maximum in dynamic response from each individual head-unit/amplifier/speaker combi-
nation, it is important to set the respective input level controls („GAIN“) of this amplifier correctly.
Before you start, you MUST set all tone controls (Bass, Mid, Treble, Loudness etc.) and the fader on the
head unit to their neutral or center positions.
Now turn the input gain controls of the installed amplifier anti-clockwise to its minimum position.
Set the volume control of your head-unit to approximately ¾ of full volume, while playing a dynamic
piece of music. Slowly increase the input gain control by turning the GAIN control clockwise until you
can just about hear distorted sounds coming out of your subwoofer system. Reduce the main volume
level on your head-unit to a medium listening level.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Emphaser ea 1500 flx at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Emphaser ea 1500 flx in the language / languages: English, German as an attachment in your email.

The manual is 2,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info