Manual EMOS SELECT 9010 (page 9 of 219) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish)

784685

Zoom out

Zoom in

1/219

MOUNTING POLE AND DIRECTION ALIGNMENT

Install the wireless 7-IN-1 sensor in an open

location

with n o obstructions above and around the

sensor

for accurate rain and wind measurement.

Install

the sensor with the smaller end facing the

North to properly orient the wind direction vane.

Secure

the mounting stand and bracket (included)

to a post or pole, and allow minimum 1.5m o

ff the

ground.

Point to

NORTH

1.5 meter

off the

ground

Fixed pole

package not

included

Add rubber

pad before

mounting on

pole or post

INSTALL WIRELESS INDOOR SENSOR

1. Remove the battery door of the sensor.

2. Use the channel slide switch to set the channel number for the

sensor (e.g. Channel 1)

3. Insert 2 x AA size batteries into the battery compartment and close

the battery door according to the polarity information marked on the

battery compartment.

4. The sensor is in synchronization mode, and can be registered to the

console within the next few minutes. The transmission status LED

will begin to ash every 1 minute (on the front of the sensor).

NOTE:

- If you need to re-assign the sensor channel, slide the channel slide switch to the new channel

position. For the new channel number to be effective, press [ RESET ] key on the sensor.

- Avoid placing the sensors in direct sunlight, rain or snow.

- To avoid the sensor/s and console pairing failure during new console setup, please power up

the sensor/s rst, and then press [ RESET ] key on the main unit (no need on sensors).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of EMOS SELECT 9010 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 11.14 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

EMOS SELECT 9010 Manual

Product: