499617
5
Zoom out
Zoom in
Previous page
1/9
Next page
5 | ENGLISH
The fixing brackets or fixing screws of the blanking cover may also not press against
the housing; if necessary, change the mounting position of the dimmer accordingly.
Risk of fatal injury from electrical current.
The outputs may carry an electrical voltage even when the dimmer is switched off.
Always disconnect the fuse in the incoming circuit from the supply before working on
connected loads.
1. Disconnect the circuit from the mains.
2. Connect the dimmer as shown (Fig. 1):
a. Neutral conductor at terminal "N" (A).
b. Phase at terminal "L" (B).
c. Luminaire at terminal "~" (C).
d. Extension push-button (optional) at terminal "1" (D).
3. Place the antenna as far as possible from metal parts (connecting cables,
retaining rings, etc.) to avoid interruptions to the Z-wave signal.
Metal surfaces in the immediate vicinity of the dimmer can affect reception. Therefore,
do not install the dimmer in a flush-mounted box made of metal.
3.0 How to put the dimmer into operation
After installation:
1. Switch on the mains voltage.
2. The connected luminaires flicker for around ten seconds and then switch off
again. The dimmer has detected the load and is ready for operation.
Note: The lights will flicker in this way (load detection) after every interruption in the
mains voltage.
3.1 Add the switch to an e-Domotica e-Centre
1. Make sure your computer is completely started.
2. Open your computer’s web browser.
3. Enter “http://ecentre” in the address bar of your web browser and press the
‘Enter’ key on your keyboard.
4. The webpage of the e-Centre will be shown. If the Wizard is started, click ‘Exit
Wizard’ to go to thee-Domotica Products’ page.
5. Click the ‘Include’ button. The e-Centre will start to search for new e-Domotica
devices.
6. Press the button on the dimmer three times within 1,5 seconds.
7. A message will appear: ‘Product found’.
If the device is not found, press the ‘Exclude’ button in the e-Centre’s webpage and
then click the button on your switch. After this procedure you can add the new device
correctly.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eminent EM6610 e-Domotica at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eminent EM6610 e-Domotica in the language / languages: English as an attachment in your email.

The manual is 0,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Eminent EM6610 e-Domotica

Eminent EM6610 e-Domotica User Manual - German - 10 pages

Eminent EM6610 e-Domotica User Manual - Dutch - 9 pages

Eminent EM6610 e-Domotica User Manual - French - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info