500134

Eltax Home Cinema 1 Manual

7
Zoom out
Zoom in
Previous page
1/18
Next page
7
Active Subwoofer
Carefully unpack the Eltax Active subwoofer and check
for any damages. If possible, keep the carton box in case
future transportation is needed.
You should immediately contact your dealer if the active
subwoofer is damaged.
Installation
There are two ways to install Your new subwoofer ; below
we will describe how:
1. From amplier with pre out to subwoofer:
Connect the power cord from the amplier pre out to Line
In on Your active subwoofer. Hereby the sound signal runs
from amplier subwoofer pre out to Your active subwoofer.
(See Fig 1 on page 13)
2. From amplier speaker out to subwoofer:
Connect the speaker cords from the amplier speaker
terminations to High Level In on Your active subwoofer.
Make sure that the right channel on the amplier is con-
nected to the right channel on the subwoofer. Repeat the
same check for the left channels. Next, connect the front
speakers from High Level Out on Your active subwoofer.
Make sure that the right channel on the subwoofer is con-
nected to the right speaker. Repeat the same check for the
left channel.(See Fig 2 on page 14)
Functions
Volume control
The sound level of the active subwoofer can be adjusted.
Use the volume control carefully, remember that pro-
gramme material may contain very high energy.
Placement
Your active subwoofer is designed to re-produce music
information in the frequency range below 100Hz. The
human ear is not able to localize sound for these low
frequencies, this is why the placement of the subwoofer
is not critical.
However you can use the nature of the acoustic laws in
the following ways:
a. To get the most amplication of the room itself, place
the active subwoofer close to a corner at a distance of
about 10 cm from the walls. If you get to much bass please
move the subwoofer out from the corner. (See drawing A
on page 11)
b. By experimenting with the placement of the subwoofer
you can optimize the sound quality. One good rule is
to place the subwoofer near the satellite speakers. (See
drawing B on page 11)
c. Never cover the built-in amplier.
Aktiv Subwoofer
Aufbau
Packen Sie den aktiven Subwoofer mit grosser Vorsicht
aus und heben Sie die Originalverpackung auf.Wenn ein
Schaden am Gerät festzustellen ist, kontakten Sie unver-
züglich Ihren Händler.
Man kann den aktiven Subwoofer auf 2 Weise aufbauen -
unten werden die Möglichkeiten geschildert:
1. Verbindung von Verstärker (Subwoofer pre out)
zum Subwoofer:
Verbinden Sie das Kabel vom Verstärker Subwoofer pre
out mit dem Subwoofer (Line In (1)). Hiermit läuft das
Lautsignal vom Subwoofer pre out zu Ihrem aktiven
Subwoofer.(s. Abb. 1 Seite 13).
2. Verbindung vom Verstärker (Speaker out) zum Sub-
woofer:
Verbinden Sie das Kabel der Lautsprecheranschlüsse
des Verstärkers mit dem aktiven Subwoofer (High Level
In ) Beachten Sie, dass der rechte Anschluss des Ver-
stärkers mit dem rechten Anschluss des Subwoofers ver-
bunden werden muss. Das gleiche gilt für die linken
Anschlüsse. Die Satelliten oder Frontlautsprecherboxen
werden darauf mit dem Subwoofer verbunden (High Level
Out ). Beachten Sie, dass der rechte Anschluss des Sub-
woofers mit dem rechten Lautsprecher verbunden werden
muss. Das gleiche gilt für die linken Anschlüsse.(s. Abb.
2 Seite 14).
Funktionen
Lautstärkenregler
Die Lautstärke des Subwoofers wird direkt am Subwoofer
geregelt. Vorsicht bei der Einstellung der Lautstärke. Es
sind oft grosse Lautstärkenuntrerschiede in verschiede-
nen Sequenzen eines Filmes; daher ist Genauigkeit bei
der Einstellung erforderlich.
Standort
Das menschliche Ohr kann die Frequenzen des aktiven
Subwoofers nicht orten, da sie bei unter 135 Hz liegen.
Folgendes muss aber trotzdem bei der Plazierung des
Subwoofers beachtet werden:
1. Damit der Raum die Basstöne verteilen kann, stellt
man den Subwoofer am besten in eine Ecke mit etwa 10
cm Abstand zur Wand. Wenn die Basswiedergabe etwas
zu kräftig ist, einfach etwas von der Wannd abrücken. (s.
Abb. A Seite 11).
2. Der Subwoofer sollte in der Nähe der Satelliten aufge-
stellt sein (s. Abb. B Seite 11).
3. Der Subwoofer darf nicht zugedeckt werden.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eltax Home Cinema 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eltax Home Cinema 1 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info