13.
Connections
Antenna Connection
The clock radio comes with an FM wire antenna at the rear; please extend for best reception.
Power Source
The unit is powered by 230V~50Hz mains power supply. The 3V Lithium button cell CR2032 (not supplied) is used
for clock back-up only. Please remove the battery during long period of non-use to avoid battery leakage.
To avoid damages not covered by the warranty only connect the unit to above power supply.
Insert/Change Back-Up Battery
Insert the back-up battery in the battery compartment at the bottom of the unit; you need a Phillips screwdriver to
open the battery compartment. Please observe the polarity.
Change the back-up battery once a year.
Your settings (alarm, current time, etc.) are retained during power failure or when temporarily disconnecting from
mains power supply; the unit automatically switches to back-up battery.
Basic Operation
Turn Clock Radio On/Off
Turn the radio off with the on/off , when not in use. Turn volume min/max to adjust the volume.
Select the frequency band with the band selector band am/fm, toggle between FM and AM.
After use, please turn the unit off. To save energy, please disconnect the unit from mains power supply and remove
the battery to avoid battery leakage when not in use for a long period of time.
The display either shows the current time or the frequency of the radio station.
The unit is designed for continuous operation; it is either in ON mode or in standby mode.
Display Brightness
You can set the brightness of the display with the toggle switch dimmer low/high at the rear of the unit. Set to low for
dim backlight, set to high for a brighter display.
Set Current Time
When first connecting the unit 0:00 is displayed.
Press and hold the time button and simultaneously press hour to set the hours in 24-hour mode.
Press and hold the button for fast setting or tap it briefly to increase the setting by one hour.
Now set the minutes with time (press and hold) and min.
Press and hold the button for fast setting or tap it briefly to increase the setting by one minute.
The current time is set.
Radio
Press on/off to turn the radio on. The display shows the frequency band (AM or FM) and the frequency (e.g. 100.6
MHz and 525 KHz). Select the frequency band with the band selector band am/fm, toggle between FM and AM.
With tuning you tune into your favourite station, the frequency is displayed in large digits on the display.
Turn volume min/max to adjust the volume.
Press on/off to turn the radio off.
The radio comes with an FM wire antenna; please unwind for best reception. For best AM reception please direct
the radio.
