13. 12.
LOCATION OF CONTROLS
PHONO COVER ASSEMBLY
1. Insert the bracket into rear side of the appliance.
2. Connect the bracket to the phono cover.
3. Connect the hinges on the phono cover to the appliance.
POWER SOURCE
AC POWER SOURCE
You can provide power supply for the appliance by plugging the AC power cord at the back of the
appliance into a proper AC wall outlet. Check if the rated voltage of your appliance matches the local
one.
PLATTER
SPEED
SELECTOR
PICKUP
TONE ARM
PHONO OPERATION
BASIC OPERATION
NOTE:
Remove the protection materials on the tone arm. Be sure that the tone arm can be detachable from
its rest before operation and resume its position again afterwards.
1. Adjust the volume control knob to the desired level to turn on the appliance.
2. Adjust the speed selector to a proper level, depending on the record to be played.
3. Place a record on the platter.
4. Lift the tone arm from its rest and gently move and place it onto the record. The platter will start
to rotate.
5. Place the tone arm on the desired position.
6. At the end of the record, the platter will automatically stop rotating. Lift the tone arm from the
record and place it again to its rest.
7. To stop manually, lift the tone arm from the record, and place it to its rest.
NOTE:
For some records, no “automatic stop” area exists (by “automatic stop”, the appliance will stop
playing before it goes to the last track of the record). In this case, adjust “AUTO STOP” to “OFF”
position, it will go to the end of the record, but will not stop automatically (Adjust the volume control
knob to “OFF” position or adjust “AUTO STOP” to “ON” position in order to stop playing). Replace the
tone arm to its rest.
PICKUP REPLACEMENT
Replacement of a worn pickup can be easily accomplished as follows:
1. To remove the worn pickup, pull out the pickup assembly as
shown in the figure with one hand, holding the pickup housing
with the other hand.
2. Then, install a new pickup by pushing it into the cartridge
gently (note: please hold the pickup by the edge to avoid
damage to the pickup) until it clicks into its place.
SPECIFICATIONS
GENERAL
Power supply : AC 230V ~ 50Hz
