678976

Elson Zircon Manual

11
Zoom out
Zoom in
Previous page
1/24
Next page
11
SAFETY
DISCONNECT FROM THE MAINS ELECTRICAL
SUPPLY BEFORE REMOVING ANY COVERS.
Never attempt to replace the immersion heater(s)
other than with the recommended immersion
heater(s).
DO NOT BYPASS THE THERMAL CUT-OUT(S)
IN ANY CIRCUMSTANCES. Ensure the two
male spade terminations on the underside of the
combined thermostat and thermal cut-out are
pushed rmly onto the corresponding terminations
on the element plate assembly.
In case of difculty contact service support; contact
details available at the back of this booklet.
ELECTRICAL SUPPLY
All electrical wiring should be carried out by a
competent electrician and be in accordance with the
latest I.E.E Wiring Regulations.
Each circuit must be protected by a suitable fuse
and double pole isolating switch with a contact
separation of at least 3mm in both poles.
The immersion heater(s) should be wired in
accordance with Fig 7. The immersion heaters
MUST be earthed. The supply cable should be
1.5mm
2
3 core HOFR sheathed and must be routed
through the cable grip provided with the outer sheath
of the cable rmly secured by tightening the screws
on the cable grip.
DO NOT operate the immersion heaters until the
cylinder has been lled with water.
Ensure the thermostat and thermal cut-out sensing
bulbs are pushed fully into the pockets on the
element plate assembly.
PLUMBING CONNECTIONS
Direct cylinders require the following pipework
connections.
• Cold water supply to and from inlet controls.
• Outlet to hot water draw off points.
• Discharge pipework from valve outlets to
tundish.
INSTALLATION - DIRECT
Fig. 7: Electrical connections (direct schematic)
N
L
1.5mm² 3 Core
HOFR sheathed
cable
… 11 …


Need help? Post your question in this forum.

Forumrules
1

Forum

elson-zircon

Reset search

  • Hi. My cylinder is getting too hot. Boiler continues to run for hot water when programmer is off for heating and hot water. Diverter valve is working so what else could be causing this? Submitted on 14-1-2023 at 11:28

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elson Zircon at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elson Zircon in the language / languages: English as an attachment in your email.

The manual is 2,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info