706426
4
Zoom out
Zoom in
Previous page
1/18
Next page
- 3 -
Power supply
The alarm unit can be powered using either the supplied adapter or with batteries. This makes it
suitable for use at locations without electrical outlets nearby.
To use with supplied adapter: Connect the adapter, see (a).
To use with batteries: Open the battery compartment see (b) and insert 8 x 1.5 V DC AA
batteries. Attention: Remove the batteries if you will not be using the alarm unit for an
extended period of time.
Setting the detection range
Open the battery cover of the alarm unit and use the
switch to experimentally adjust the range of the radar
sensor:
HI
- < 6 m. from the front of the alarm unit
- 9-16 m. from the back of the alarm unit
MID
- < 4 m. from the front of the alarm unit
- 6-9 m from the back of the alarm unit
LOW
- < 2 m. from the front of the alarm unit
- 3-6 m from the back of the alarm unit
Switching on the alarm
When the alarm unit is powered, the led POWER will
light up.
To activate or deactivate the alarm, press the On/Off
button at the top of the alarm unit. When the alarm is activated, the led ARM will light up.
To change the alarm signal, press the Select button.
Use the Vol + and Vol - buttons to change the alarm volume.
After switching the alarm unit in alarm mode, it takes about 15 seconds for the radar sensor to
detect movement. This delay allows you to leave after the room without triggering the alarm
unit.
If the alarm unit is triggered it will start alarming. Depending on the alarm signal you have
selected, it will stop alarming a few seconds after them motion was detected.
- Barking dog : Stops approx. 20 seconds after last motion detection
- Police alarm : Stops approx. 50 seconds after last motion detection
- Doorbell : Stops immediately after the last motion detection
HI MID - LOW
Back
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elro ARD51 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elro ARD51 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info