614473
20
Zoom out
Zoom in
Previous page
1/100
Next page
14
Attaching and Removing Shank
Turn OFF the power switch.
Raise the presser bar.
Turn the setscrew q counterclockwise with the
screw key to remove the shank.
To attach, match the hole in the shank w with the hole
in the presser bar e. Put thumbscrew in hole and turn
clockwise to tighten.
Attaching and Removing Presser Foot
Press the Up/Down Needle key until the needle
is in the raised position.
Turn OFF the power switch. Raise the presser foot
and press the lever q on back of the shank.
The presser foot will drop off.
Place the selected presser foot so the pin e on
the foot lies just under the groove w of the shank.
Lower the presser bar and attach the foot.
Each foot is marked with a letter for identification r.
How to Drop the Feed Dog
The feed dog can be dropped out of position for
special sewing techniques: free motion embroidery,
stippling, button sewing, etc.
Locate the feed dog lever on the back of the machine.
Slide the lever either to the right (down) q or to the
left (up) w. To bring up the feed dog e, hand turn the
flywheel r after sliding lever to the left.
NOTE:
The feed dog should be in the up position for regular
sewing. Turn the flywheel toward you to check if the
feed dog comes up after setting the lever in the up
position.
q
w
e
r
q
w
e
r
q
w
q
q
w
w
e
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elna Lotus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elna Lotus in the language / languages: English, German, French as an attachment in your email.

The manual is 3,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Elna Lotus

Elna Lotus User Manual - English - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info