614468
56
Zoom out
Zoom in
Previous page
1/96
Next page
56
3 Pull the buttonhole lever down as far as it will go.
4 Buttonhole lever
4 Raise the foot and pass the needle thread through
the opening in the foot. Draw both needle and bobbin
threads to the left.
Insert the fabric under the foot and lower the needle
into the fabric at the starting point.
Lower the foot.
5 Needle thread
6 Bobbin thread
7
Opening
8 Starting point
NOTE:
Make sure there is no gap between the slider and front
stopper. If there is a gap, the length of the right and left
rows of the buttonhole will differ.
9 Slider
Front stopper
Difference
There should be no gap.
5 Sew slowl
y
and stop the machine when a buttonhole
is completed.
The machine sews the front bartack and left row first,
then the back bartack and right row.
6 Raise the foot and remove the fabric.
Cut both needle and bobbin threads leaving about 4"
(10 cm) thread ends.
Draw the needle thread to wrong side of fabric by
pulling the bobbin thread.
Then,
knot
the
threads.
Insert
a
pin
inside
the
bartack.
Then
cut
the
opening
with
seam
ripper.
Take
care
not
to
cut
the
stitches.
11
12
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elna eXplore 340 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elna eXplore 340 in the language / languages: English, German, French as an attachment in your email.

The manual is 18,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info