614465
30
Zoom out
Zoom in
Previous page
1/90
Next page
26
Winding a Bobbin
1. Pull out the flywheel to keep the needle from
moving up and down.
2. Place the spool of thread on the spool pin with
the thread coming off the spool as shown. Pull
the thread over around the bobbin winder thread
guide.
3. Pass the thread through the hole in the bobbin
from inside to the outside. Place the bobbin on
the bobbin winder spindle.
4. Push the bobbin winder spindle to the right.
5. Hold the free end of the thread and press the
foot control. Stop the machine when it has made
a few turns and cut the thread tail close to the
hole in the bobbin.
6. Press the foot control again until the bobbin is fully
wound. Return the bobbin winder spindle to the
left and cut the thread.
7. Push the flywheel back into place. (The machine
needle will not go up and down until you push in
the flywheel.)
1
2
3
4
5
6
7
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elna eXplore 220 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elna eXplore 220 in the language / languages: English, German, French as an attachment in your email.

The manual is 5,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info