614483
93
Zoom out
Zoom in
Previous page
1/112
Next page
92
Stipple quilting with the AQ design patterns
First sew the center-most pattern of the quilt.
Remove the hoop AQ and quilt layers after the first section
is finished.
NOTE:
To remove the magnetic clamp, tilt and roll it off the frame.
Place the template sheet on the next section to sew and
adjust the position of the template sheet by aligning it with
the first pattern sewn.
Mark the reference lines for the second section.
Set the quilt layers in the hoop AQ and remove pins and
basting stitches from the hooped area.
Attach it to the machine (see the previous page).
NOTE:
Provide a wide space around the machine.
Prevent the free end of the quilt layers from hanging down
from the sewing surface. The use of the optional
clothsetter table is recommended.
Sew the second section. Repeat this step until the entire
area is filled with the stippling pattern.
If you need to sew the quilt upside down, flip the design
pattern in the editing mode after setting the hoop.
If the outer edges of each section do not align with each
otherdue to shrinkage, adjust the pattern size of the outer-
most section.
To adjust the pattern size, select the current pattern again
and press the key to open the single pattern adjusting
window.
Select the dimension or percentage, and press the “+” or
“–” key to adjust the pattern size.
Press the OK key and sew the design pattern in the
adjusted size.
CAUTION:
Make sure the hoop AQ is removed from the carriage
before to the home position. Otherwise the magnetic
clamps may hit the embroidery foot.
NOTE:
For the needle thread, the following brands are
recommended:
• Robison Cotton (50 weight)
• Coats Cotton
• Madeira Polyester (No. 120)
• Sulky Cotton (30 weight)
Reduce the sewing speed for a better result.
1
0
4
7
2
56
9
8
3
60mm
100%
90mm
100%
Adjust Design Dimensions
93


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elna 9600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elna 9600 in the language / languages: English as an attachment in your email.

The manual is 17,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info