703983
94
Zoom out
Zoom in
Previous page
1/117
Next page
94
SECTION VI
Sewing Techniques
Overlocking Outside Corners
Stop sewing when you reach the end of the
fabric, leaving the needle in its highest
position. Raise the presser foot. Push the
tension release lever while gently removing
the stitches from the stitch finger. Turn fabric.
Align the sewn stitches with the needle. Lower
the presser foot and pull up on the needle
thread to remove any slack. Sew.
If you are overlocking and trimming at the
same time, you should cut the fabric by hand
at each corner along the stitching line for
about 3 cm (1 1/2”) before turning the fabric.
Make the cut to each corner before sewing
begins.
Overlocking Inside Corners
1. Clip the inside corner approximately 4 mm
(1/4”).
2. Fold the fabric into a straight edge and
sew along the edge. The movable cutting
blade should barely trim along the fabric
edge.
3. Unfold fabric and press it.
Sewing Curved Edges
For inside curves, guide the fabric gently,
applying pressure with your left hand at point
"A” in the direction of the arrow, while at the
same time applying a little pressure in the
opposite direction with your right hand at point
“B”.
For outside curves, sew in a similar manner,
but by applying the pressure in the opposite
directions.
94


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elna 845 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elna 845 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 11,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Elna 845

Elna 845 Additional guide - English, German, French, Spanish - 9 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info