614452
70
Zoom out
Zoom in
Previous page
1/100
Next page
68
Securing Ends
To avoid unravelling, it is necessary to leave a
thread chain about 5 cm (2˝) long at the beginning
and at the end of a seam. To secure the beginning
and end of a seam, choose one of the following
methods.
At the beginning
A. Separate the end of the threads and knot them.
B. Thread the chain through a large eyed needle,
and weave that chain through the overlock
stitches on the fabric.
C. Cut the chain at the edge of the fabric. Then
apply a small amount of seam sealant on the end
of the threads.
D. 1. Before putting your fabric on the machine, sew
a thread chain about 5 cm (2˝) long behind the
needle.
2. Put your fabric on the machine. Then serge a
few stitches and stop.
3. Raise the presser foot and bring the thread
chain from the left around and under the
presser foot.
4. Place the thread chain between the presser
foot and upper knife, holding it in position as
you lower the presser foot to sew.
5. After sewing about 2.5 cm (1˝), move the chain
to the right and under the upper knife, cutting
the chain as you sew.
At the end of a seam
* You can use the same methods as “At the
beginning” to secure the end of a seam except
“D” or you can use the method shown below.
1. Serge one stitch off the end of a seam.
2. Raise the needle and presser foot, and gently pull
the threads off the chaining finger.
3. Turn the fabric over so that the under side is up.
4. Serge about 2.5 cm (1˝) over stitching and angle
off the fabric.
A
B
C
D
1
2, 3
4
1, 2, 3, 4
5
70


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elna 664 PRO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elna 664 PRO in the language / languages: English, German, French as an attachment in your email.

The manual is 5,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Elna 664 PRO

Elna 664 PRO User Manual - English - 50 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info