614452
62
Zoom out
Zoom in
Previous page
1/100
Next page
60
q
w
u
r
t
y
e
Threading the Needle with the Needle
Threader
The needle clamp can be tilted up for easy threading
(see page 30).
When rethreading, remove the thread from the
needle eye before tilting up the needle clamp.
IMPORTANT:
When tilting up the needle clamp, be sure to:
turn the power switch off.
turn the handwheel toward you and match the
alignment marks.
lower the presser foot.
q Power switch
w Alignment marks
Hold the needle threader with the triangle mark
facing up. Insert the thread into the Y-notch of the
threader from the right.
e Triangle mark
r Y-notch
Slide the threader down along the needle while
pushing it gently until the threader pin goes into
the needle eye.
Place the V-notch over the needle just above the
needle eye.
t V-notch
Push the threader until the threader pin comes out
through the needle eye with a loop of thread.
y Threader pin
Remove the threader from the needle slowly, leaving
the thread loop behind the needle eye.
Using the hook, pull the loop of the thread out
to the back.
u Hook
CAUTION:
Do not turn the hand wheel when the needle clamp is
being tilted up, otherwise it may cause a damage to
the needle clamp.
62


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elna 664 PRO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elna 664 PRO in the language / languages: English, German, French as an attachment in your email.

The manual is 5,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Elna 664 PRO

Elna 664 PRO User Manual - English - 50 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info