668330
50
Zoom out
Zoom in
Previous page
1/56
Next page
Elma 22 - 25 - 27 Page 49
5) Maintenance
WARNING
To avoid electrical shock, disconnect test leads from live circuits before opening the case.
Do not operate with open case.
Cleaning and Storage
Periodically wipe the case with a damp cloth and mild detergent; do not use abrasives or
solvents. If the meter is not to be used for periods of longer than 60 days, remove the
battery and store it separately
Trouble Shooting
If the instrument fails to operate, check battery, leads, etc., and replace as necessary.
Double check operating procedure as described in this user’s manual
If the instrument voltage-resistance input has subjected to high voltage transient (mostly
caused by lightning or switching surge to your system) by accident or abnormal conditions
of operation, the series fusible resistors will be blown off (become high impedance) like
fuses to protect the user and the instrument. Most measuring functions through this input
will then be open circuit. The series fusible resistors and the spark gaps should then be
replaced by qualified technician. Refer to the LIMITED WARRANTY section for obtaining
warranty or repairing service.
Battery Replacement
If the meter starts up with persistent resetting display or with low battery icon turns on,
replace the battery ASAP. The meter uses one 3V coin battery IEC-CR2032.
Before opening the case bottom, make sure the meter is switched off to avoid abrupt
power reset to a running meter system. Disconnect test leads from live circuits. Loosen the
screw from the case bottom. Lift the end of the case bottom nearest the input test leads
until it unsnaps from the case top. Replace the battery. Observe battery polarities with
positive (+) faces up (towards the case bottom). Replace the case bottom, and ensure that
the snap on the case top (near the LCD side) is engaged. Re-fasten the screw.
Note for BM27 and BM25 battery replacement:
*BM27 and BM25 use micro-controller (like a computer) to run the meter system. WHEN
THE METER IS POWER-ON, intermittence battery power failure (fast intermittence battery
contact interval in the order of millisecond) may cause the meter reset/re-startup
abnormally. Simply press and hold the SELECT button for approximately 6 seconds to
master reset the system if such a situation occurs.
6) Specification
General Specifications
Display & Update Rate:
BM22: 3-3/4 digits 4000 counts; Updates 3 per second nominal
BM25 & BM27: 3-5/6 digits 6000 counts; Updates 5 per second nominal
Operating Temperature: 0
o
C ~ 40
o
C
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elma 25 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elma 25 in the language / languages: Danish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 1,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info