Manual Elkron ELR600RT-15 (page 21 of 28) (English, Italian)

741404

Zoom out

Zoom in

1/28

ELR600RT/10-15-20



A barrier alignment test can be made at this point. At optimal alignment, the BLUE test LED and the buzzer

emit a continuous signal.



To exit the test phase, switch the TEST DIP1 to OFF on the RX barrier; the red LED will flash and the WALK

TEST function with be activated. In the event that a beam is interrupted (or two beams if the AND option is

selected), the barrier will emit a continuous sound for 30 seconds. The blue LED will flash as the tampers

are open on the motherboards of the RX and TX barriers. At this stage, the conrol unit will show a tamper-

open signal.



Interrupt each beam to check that all the optics and the acoustic signal are working properly.



At the end of this stage, the BLUE test LED will light up and the red LED will flash until TEST DIP 1 on the

TX barrier motherboard is switched to OFF.



Switch TEST DIP1 to OFF.

Note: the wire terminal board on the TX barrier is not to be used

REASSEMBLING THE BARRIER

Reinsert the plastic profile, taking particular care to keep the tamper switch on the barrier motherboard circuit

pressed to avoid damaging it.



Ensure that the square gasket shown in the figure below is in place:



Insert the standard cap into the aluminium profile until they meet. If it is deemed necessary to secure the

standard cap to the aluminum profile, use the screw supplied. To do this, remove the transmitter holder and

slide the plastic profile a few centimeters in the direction of the transmitter holder.



Do the same with the TX barrier.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Elkron ELR600RT-15 in the language / languages: English, Italian as an attachment in your email.

The manual is 1,27 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Elkron ELR600RT-15 Manual

Product: